This kit allows the students to investing the nature and properties or electricity using simply circuits easily constructed on a baseboard. Spring connectors are used to have different circuits for study.

1 Baseboard 35cm square with a matrix of metal peg terminals at 9 cm. Spacing and the battery holders mounted on a hard board. Pegs adjacent to battery holders are drilled to accept 4mm plug, with rubber feet.

20 Flash lamp bulbs, 1.25 volt, 0.25 Amp

3 Leak proof batteries 1.5 volts

10 Connectors with lamp holders

12 Ordinary connectors

1 connector with a rheostat of 25 ohms, 1 watt, wore wound

1 Silicon rectifier, 1 to 500mA, PIV 50 Volt

1 Resistor, 3,9 ohms, 5watt.

2 Flexible leads with 4mm plug and crocodile clip

2 Flexible leads with crocodile clip

2 Crocodile clips

2 Connectors with contact key

2 Soft Iron nails, length 5cm square head

1 Reel of 20 SWG, bear copper wire

1 Reel of 34 SWG, bear copper wire

1 Reel of 26 SWG, PVC covered copper wire

1 Electrode support disc, hard board, 75mm diameter with two holes 1 inch a part to take pencil electrodes when investigating the electrical conductivity of different liquids .

2 Pencil lead electrodes 100x2mm, length x diameter
1 Sheet of copper foil, to be cut into strips to make electrodes for copper plating experiments 15cm square

Packed of steel wool.